Hummer H3.8 2KW Wind Turbine Generator
2 KW Hummer wind turbine which has rotor diameter of 3.8 meter and a tower of 10 meter height. All the parts of the wind turbine are tightly connected to ens…
11 Responses to Hummer H3.8 2KW Wind Turbine Generator
Leave a Reply
Thanks Cobra. I took some time and balanced the blades. the turbine is
running fine just don’t have the time to put the video together and post
it.
Anthony Felix
October 29, 2014 at 10:11 pm
Dayı bunun motor kaç basıyo
Ne motoru bu
Mehmet Aşık
October 29, 2014 at 10:12 pm
it took me about three weeks to get my homemade blades balanced. it was a
pain in the rear.
gettinready101
October 29, 2014 at 11:04 pm
Other reason why rotor vibrate is when it is near the roof. The velocity of
wind near the roof is lesser than near the top. When the blade is near the
top it receives higher pressure than when it is near the roof, it creates
vibration. Because of roof obstruction the flow of wind is directed upward
and that is the reason why wind pressure striking the blade is not even.
diegofacundouri
October 29, 2014 at 11:14 pm
Turbine will shake if the rotating parts are not balance..
diegofacundouri
October 30, 2014 at 12:04 am
how is it doing now after 2 years? any problems?
CobraWind Turbines
October 30, 2014 at 12:14 am
Hummer does not honor warranty bad turbines they run less then 6 months
5kw,10kw,20kw
TheEvolveGreen
October 30, 2014 at 1:10 am
Nice turbine setups you have, hope you get the vibration issue solved.
Justin AndersonMusic
October 30, 2014 at 1:56 am
Your tower got guys wires? if not it should have a steh shaking is occuring
because your towewr is not big enough or supported enough to dampen the
blades inertia.
markdredgediver
October 30, 2014 at 2:21 am
Thanks Ian. I am not an expert on blades but I will look into it.
Anthony Felix
October 30, 2014 at 3:14 am
hope you can fix you vibration problem in my experiance its the blades.best
to weigh each blade first before any thing else right down to the nearest
gram. before trying any thing else. then dynamic balance and static balance
of the blades.hope this may help in some small way.
ian57812
October 30, 2014 at 3:22 am